AWK-3131A-M12-RCC
Web Console Configuration
3-48
Locate Device
When you click on the Start to Locate button, the AP will beep and the AP’s LED will flash making it easy to
identify the AP. To stop the beeping, click on the Stop locating button.
Misc. Settings
Additional settings to help you manage your AWK-3131A-M12-RCC, are available on this page.
Reset button
Setting
Description
Factory Default
Always enable
The AWK-3131A-M12-RCC’s Reset button works normally.
Always enable
Disable ‘restore to
default function’ after
60 sec
The AWK-3131A-M12-RCC’s reset to default function will be
inactive 60 seconds after the AWK-3131A-M12-RCC finishes
booting up.
Save Configuration
The following figure shows how the AWK-3131A-M12-RCC stores the setting changes into volatile and
non-volatile memory. All data stored in volatile memory will disappear when the AWK-3131A-M12-RCC is
shutdown or rebooted unless they are y. Because the AWK-3131A-M12-RCC starts up and initializes with the
settings stored in flash memory, all new changes must be saved to flash memory before restarting the
AWK-3131A-M12-RCC. This also means the new changes will not work unless you run either the Save
Configuration function or the Restart function.
