Movado 1604327, Инструкция по эксплуатации, гарантия и руководство по обслуживанию

Страница: 11 / 102

21 20
To close the clasp: (See Figure K)
1.Press firmly on the push-button, holding it in as
you fold the clasp into its closed position.
2. When you feel clasp snap shut, release push
button.
3.Your new Movado SE strap watch is now secured
on your wrist and ready to wear.
To size the SE leather strap: (See Figure L)
1. Holding the strap in one hand with the outer
side facing you, as shown, use the index finger
on your other hand to flip the attachment bar
part of the clasp open.
2. From the inner side of the strap, lift the prong
from its hole. (see Figure M)
3. Slide the attachment bar with prong along the
strap until it is in the desired new position,
then push the prong back through the
alternate strap hole.
4. From the outer side of the strap, press the
attachment bar closed, locking the clasp in its
new position.
Figure K
Figure L
Figure M
Movado SE
™
Strap
Deployment Buckles
The colored leather or rubber strap on your new
Movado SE features a special folding deployment
clasp with push-button release.
Operating Instructions
To attach SE rubber strap:
1. Slide strap tip under bar on inside of detached
end of clasp, and pull through, adjusting length
to fit wrist.
(See Figure H)
2. Fold strap back and slip edges under the hooks
to secure strap in position with excess length
hidden under strap.
(See Figure J)
3. Check fit, adjust if necessary, then pull to tighten.
To open the clasp: (See Figure K)
CAUTION: Do not pull on the strap or attempt to
pop the clasp open with a fingernail. Doing so
could damage the clasp’s lock/release mechanism.
1. Holding the clasp between your thumb and
index finger as shown, apply pressure to the
push-button.
2. As you press it in firmly, the push-button will
retract, releasing the locking mechanism and
allowing you to open the deployment clasp.
Figure H Figure J