Section 1
Overview
1-8 WR850
LED Description
LED
Condition
Color Status
1 Power
ON
Green
The device is powered on and operating normally.
ON
Red
The Power LED turns
RED
as soon as the reset
button is depressed. If the reset button is held
down, the LED starts to blink
RED
and the
router’s username, password, private LAN IP
address, private subnet mask address and
operation mode are restored to factory default
settings.
If the Power LED stays
RED
for longer than 5
seconds, this indicates that the firmware is
corrupted and needs to be restored.
OFF None
The device is not powered on.
2 Modem
ON/Blinking
Amber
10BaseT link detected / active traffic present.
ON/Blinking
Green
100BaseT link detected / active traffic present.
OFF None
No external Ethernet device has been attached
and detected. The Ethernet link may be down.
3 Wireless
ON/Blinking
Green
The wireless interface is enabled / active traffic
present.
NOTE: The wireless LED does not blink on WR850G
“Version 1” hardware. You can determine
your version of hardware by looking at the
product label on the bottom of the router.
Within the box that includes the FCC logo, a
“Version 1” unit will display “MODEL:
WR850G”, while a “Version 2” unit will display
“MODEL: WR850Gv2” (see example below).
INPUT VOLTAGE: +5VDC, 2A
FCC ID: F2NWR850G
FOR HOME OR OFFICE USE
Tested To Comply
With FCC Standards
MODEL: WR850G
WIRELESS MAC: AB CD EF 01 23 45
WAN MAC: AB CD EF 01 23 45
MADE IN TAIWAN
MODEL WR850G
PART NUMBER: AAAAAA-BBB-CC
S/N: PPPPMMYJJJSSSSSCAABBCCCC
OFF None
The wireless interface is not enabled by the
firmware.
4 LAN (x4)
ON/Blinking
Amber
10BaseT link detected / active traffic present.
ON/Blinking
Green
100BaseT link detected / active traffic present.
OFF
None
No external Ethernet device has been attached
and detected. The Ethernet link may be down.
