Setting Up an Invisible Boundary Zone
29
ENGLISH
6.
Setting Up an Invisible Boundary Zone
6.1
What You’ll Need:
1.
Pet Collar Unit
2.
Test Light
3.
Wireless Fence Unit (see “Turn Fencing Mode On or Off” on page 27).
4.
Boundary Flags
6.2
Set Transmission Range on your Wireless Fence Unit
1.
Make sure that both the Pet Collar Unit and Wireless Fence Unit are
powered on (see “Powering On/Off the Pet Collar Unit” on page 22 and
“Powering On/Off the Wireless Fence Unit” on page 27).
2.
Hold the Pet Collar Unit on your hand (avoid touching the collar contacts)
and walk to your desired boundary zone.
3.
Press and hold down
PAIR KEY
and
POWER KEY
on the Pet
Collar Unit at the same time until you hear a long confirmation beep.
This indicates that the boundary is set.
6.3
Set Static Correction Level to Level 2 or 3
Press
or
to select Static Correction Level (2 to 3).
6.4
Confirm Boundary Zone
Boundary zone is an area 2 to 3 feet before the “real” boundary. When your dog
reaches the boundary zone, the Pet Collar Unit that is worn on your dog emits a
warning beep followed by static correction to get its attention until it backs away
and goes back into the boundary.
1.
Press and hold
POWER KEY
on the Pet Collar Unit to power it on.
2.
Place the Test Light Contacts over the Collar Contacts on the Pet Collar
Unit.
3.
Hold the Pet Collar Unit with the Test Light Contacts at your dog’s neck
level.
The Motorola logo should be facing away from the Wireless Fence Unit and
the Collar Contacts should be facing upwards.