4. Place the radio, or the NiMH battery in the charger adapter
cover, into the Charging Dock until you hear a click.
5. When the LED turns green, the battery is fully charged.
To Install AA Batteries:
1. Push clip upwards to remove battery cover.
2. Insert 3 AA batteries into the AA battery tray so the + and –
markings match the ones in the compartment.
3. Replace the battery cover by inserting the battery cover pegs into
the slots in the back of the radio, then press firmly until battery
cover clicks into place.
To Turn Radio On and Off:
1. Press and hold down the
P
button until the radio is on. The
LED will be solid red, the display will turn on and an audible
alert will be heard (unless the Alert tones are disabled).
2. To turn the radio off, press and hold down the
P
button, the
radio will beep to confirm (when the Alert tones are enabled)
and the display will disappear.
Battery Meter:
The
d
icon, located on the LCD, is divided into three bars.
It shows
d
(full),
b
(two-thirds full),
c
(one-third full)
and
a
(almost empty). When it’s
c
, the radio beeps
every ten minutes.
Battery Type Selection:
To ensure that the Battery Meter icon is showing accurate battery
usage, the type of battery being used in your radio should be set,
in the Battery Type Selection Menu.
1. To enter the Battery Type Selection Menu, press the
\
button
until the
d
icon appears in the display. The channel number
will be replaced by a flashing
A
or
n
.
2. Use the up
]
or down
[
button to choose either
A
, if Alkaline
batteries are being used on or
n
, if NiMH or NiCd rechargeable
batteries are being used.
3. The radio will return to the normal operating mode after ten
seconds or when you quick-press
M
or
R
.
Note:
Remove batteries before storing your radio for extended
periods. Batteries corrode over time and may cause
permanent damage to your radio.
Belt Clip:
Talkabout
TM
T6202, T6212 and T6222 radios come as standard
with a belt clip.
To Attach:
1. Holding the belt clip at the top and bottom, squeeze to retract
the hook.
2. Insert belt clip into slot on back of radio and release hold.
3. To remove, hold the belt clip at the top and bottom, squeeze
again to retract the hook and remove.
6 English
3
7
I
H
A
B
C
2
1
5
/
6
