Let’s Talk About Your New Radio
Motorola
TM
Talkabout
TM
T6202, T6212 or T6222 two-way radios
allow you to stay in touch with your family and friends. They
operate on PMR446 frequencies. They can be used in any
country where PMR446 frequencies are authorized, subject to
applicable regulations.
Batteries
Talkabout
TM
T6202, T6212 and T6222 radios operate with either
three AA batteries or a Nickel-Metal Hydride (NiMH)
rechargeable battery.
The NiMH rechargeable battery, charger adapter cover, charger
and Charging Dock can be purchased separately.
To Install NiMH Battery:
1. Push clip upwards to remove battery cover.
2. Insert NiMH battery pack with charging contacts facing out.
3. Replace the battery cover by inserting the battery cover pegs
into the slots in the back of the radio, then press firmly until
battery cover clicks into place.
To Charge NiMH Battery:
The NiMH battery can be charged while in the radio or on its own
in the charger adapter cover. To get maximum use from the
battery, charge overnight (16 hours) before you use it for the first
time. Subsequent charges will only require four hours of
charging time.
1. Ensure the radio is off or place the NiMH battery in the
charger adapter cover.
2. Plug the charger into an AC wall socket.
3. Position the charger connector with the large hook over the
large slot to the right of the three battery contacts.
4. Push the large hook into the large slot, then snap the small
hook into the small slot.
5. The light on the charger will be red while the battery is charging
and will flash green when the battery is approximately 90%
charged. The green light will be on constantly when the battery
is fully charged.
6. To remove the charger pull gently out and up until the small
hook disengages and carefully remove the larger hook.
Note:
If you notice the LED flashing red for more than a minute,
the battery is faulty and should be replaced.
Using The Charging Dock
The Charging Dock can be mounted or placed on any flat surface
(such as a wall or table). To mount the Charging Dock:
1. Wrap the power cord under the Charging Dock. Use the cutouts
to hold the cord in place.
2. Attach using two number 6 x
3
⁄
4
screws appropriate for the
mounting surface.
To charge the NiMH battery using the Charging Dock:
1. Position the charger with the hook on the LED end over the left slot.
2. Snap the hook on the cord end into the right slot, clamping the
charger onto the Charging Dock contacts.
3. Plug the charger into an AC wall socket.
5 English
A
B
C
F
G
D
/
E
