To Select The Internal VOX Feature:
Either
1. Press the
\
button until the flashing
g
icon appears in the
display and the channel number is replaced with
Y
(enabled) or
n
(disabled). Use the up
]
or down
[
button to select
Y
for enable.
2. The radio will return to the normal operating mode after ten
seconds or when you quick-press
M
or
R
. The
g
icon remains
in the display.
OR
1. Ensure radio is turned off.
2. Press and hold down the
M
button and switch on the radio
using the Power button. The
g
icon will be shown on the display.
To Use The Internal VOX Feature:
1. Quickly press and release the
M
button and the
g
icon will
begin to flash. Your radio will now transmit every time you talk.
2. Quick press
M
switches radio between muted and active
VOX modes.
3. To disable the Internal VOX feature, go into Internal VOX
Selection Menu and use the up
]
or down
[
button to select
n
for disable. Or switch the radio off and then back on again.
To Select Internal VOX Sensitivity:
Talkabout
TM
T6212 and T6222 radios allow you to adjust the
Internal VOX sensitivity of the radio to compensate for varying
levels of background noise and speech. The Internal VOX edit
mode allows you to choose between high, and low settings. For
example if you speak loudly, or are in a noisy environment, the
low setting (
1
) should be selected and if you speak softly, or are
in a quiet environment, the high setting (
3
) should be selected.
The middle setting (
2
) is suitable for most applications.
1. To enter the Internal VOX sensitivity menu, ensuring the
g
icon
is showing on the display, press the
\
button until the channel
number is replaced with an Internal VOX setting of
1
,
2
or
3
.
2. Use the up
]
or down
[
button to change the Internal VOX
setting, if required.
3. The radio will return to the normal operating mode after ten
seconds or when you quick-press
M
or
R
.
Scan:
Talkabout
TM
T6212 and T6222 radios have Scan feature which allows
you to monitor other transmitting radios. It allows you to listen and
talk back to the person(s) without having to switch channels.
Normal scan will only “land” on a channel if the Interference
Eliminator Code matches the one you set for that channel.
Carrier Squelch scan will “land” on a channel if any activity is
detected. The radio will do the Carrier Squelch scan if you set the
Interference Eliminator Code to
0
for the original channel (the
channel being used before going to Scan mode).
1. To begin scanning, quick-press the
)
button. The
h
icon
will appear in the display and the channel numbers are
scrolled through.
2. When the radio detects channel activity, the display will indicate
the channel and code on which the activity is taking place (code
will show
0
if the radio is in Carrier Squelch Scan and “lands”
on a channel where the incoming signal does not contain an
Interference Eliminator Code).
3. Pressing the
M
or
)
button while the radio is scanning will
result in transmit/monitor operation on the original channel.
4. To exit Scan, short press the
)
button again, the display will
show the original Channel and Code number and the
h
icon
will disappear.
11 English
