Motorola SYMBOL MT2000 Series, Руководство пользователя

Страница: 184 / 304

CHANGE/VIEW MTSX RSS
6-58 68P81074C50
FIELD DEFINITIONS:
System
Use the up/down arrow keys to scroll from system number 1 to the number of systems in the radio.
Tx Power Select
The transmit power may be reduced 1 watt for 800 and 900 MHz models, and 2 watts for VHF and UHF models.
Factory default is High. This feature is not available for all models.
DEPENDENCIES:
The power levels selected will depend on the alignment values, which can be adjusted under the alignment
section in the Service portion of this RSS package.
Trunk Repeater Offset
The value must be set to the frequency separation between the transmitter and receiver frequencies used at the
central repeater site. Factory default is 45MHz for 800 band and 39 MHz for 900 band.
Channel Assign Type
Sets the channel assignment type to Domestic or International. Domestic - 25 KHz channel spacing used in the
USA. International - 12.5 KHz channel spacing used outside the USA.
Splinter Channel (800 MHz Only)
The control channels will be shifted down 12.5 KHz and the radio will interpret the channel numbers received
over the air as splinter channels as well. Channels in the 821 band will not be affected. Factory default is
Disabled.
Rx Modulation
This field should be based off of the expected receive data format for the personality. This field allows the user
to configure the radio's personality for strictly binary (2-level) receive operation, strictly multi-level (4-level)
receive operation, or both binary and multi-level receive operation (Auto Receive). When operating in Auto
Receive mode, the radio will automatically detect the received signal type and process the data accordingly. As
a side note, however, 2-level sensitivity is reduced when operating in the Auto Receive mode and thus should
not be used on channels or systems that are strictly binary (2-level). This field applies only to Secure radios.
Channel Bandwidth
Use the UP/DOWN arrow keys to select the Channel BandWidth. This value must be set to the Channel
BandWidth of the system the radio is to operate on.
NOTE
Strapping fields for Announcement Group, Fleet ID, Talkgroup, etc.will be forced
to 'Clear' if 12.5 kHz is selected.
The factory default is 25.0 kHz.
ISW Retry Timer
Use the up/down arrow keys to select the value for this field.
This field changes the interim spacing between ISW retries. Spacing between retries is extended to
accommodate System access delays. Valid entries are Disabled, 25ms, 50ms, and 75ms. Factory default us
Disabled.
Phone DTMF Timing
Timing may be changed for Initial Delay, Digit Duration, and Inter Digit Delay. The radio contains a table with
four sets of values of these parameters. The actual parameters are entered on the Radio Wide Phone
Configuration screen (F4/F3/F4/F9). Factory default is 1.
NOTE
For non-keypad models-This option can ONLY be used with the One Touch
Button Feature (Main Menu F4/F4/F3/F9/F5).