Motorola P-7131N-FGR, Руководство по продукции

Страница: 73 / 700

Getting Started 3-3
3.3 Initially Connecting to the Access Point
3.3.1 Connecting to the Access Point using the WAN Port
To initially connect to the access point using the access point’s WAN port:
1. Connect AC power to the access point, as Power-Over-Ether support is not available on the
access point’s WAN (or GE2) port.
2. Start a browser and enter the access point’s static IP address (10.1.1.1). The default
password is “
motorola .”
3. Refer to Basic Configuration on page 3-4 for instructions on the initial (basic) configuration
of the access point.
3.3.2 Connecting to the Access Point using the LAN Port
To initially connect to the access point using the access point’s LAN port:
1. The LAN (or GE1/POE) port has a default static IP address of 192.168.0.1/24.
2. To view the IP address, connect one end of a null modem serial cable to the access point and
the other end to the serial port of a computer running HyperTerminal or similar emulation
program.
3. Configure the following settings:
• Baud Rate - 19200
• Data Bits - 8
• Stop Bits - 1
• No Parity
• No Flow Control
4. Press <ESC> or <Enter> to access the access point CLI.
5. Enter the default username of “ admin ” and the default password of “ motorola. ”
NOTE The procedures described below assume this is the first time you are
connecting to an AP-7131N-FGR model access point.
NOTE The computer being used should be configured to use the same IP address
and subnet mask as the access point.