4
E
n
glis
h
AUTHORIZED POWER CORDS
This charger is designed for use in 100 VAC to 240 VAC, 50/60 Hz applications
and uses the following Motorola power cords.
Table 2:
Authorized Power Cords
OPERATING INSTRUCTIONS
Multi-unit chargers will charge only the Motorola authorized batteries listed in
Table 1. Other batteries may not charge.
The charger pockets will accommodate either a radio with a battery attached or
a battery alone.
Prior to charging a battery with radio, turn the radio off.
Batteries charge best at room temperature.
Charging Procedure
1. Plug the charger end of the power supply cord into the power receptacle
located at the back of the charger.
2.
Plug the wall receptacle end of the power supply cord into the appropriate
AC outlet. A successful power-up sequence is indicated by a
SINGLE
GREEN BLINK
on the charger indicator.
3.
Insert a battery, or a radio with battery (
radio turned off
), into the
charger’s pocket by:
a. Aligning the groove on each side of the battery with the corresponding
raised rail on each side of the charger pocket
b. Pressing the battery toward the rear of the pocket
c. Sliding the battery into the charger pocket, ensuring complete contact
between the charger and battery contacts
4.
When the battery is properly seated in the pocket, the charger indicator
will illuminate
STEADY RED
to indicate that the battery is charging rapidly.
When the battery is 90% charged, the charger indicator changes to a
BLINKING GREEN
, indicating that the battery is trickle charging. When
Plug Type
Charger Kit
Power Cord
No power cord/plug
NNTN8355
None
US/NA
NNTN8353
3087791G01
Euro
NNTN8352
3087791G04
UK
NNTN8351
3087791G07
Brazil
NNTN8347
3087791G22
Argentina
NNTN8345
3087791G13
68012007024_Multi-Unit Charger.book Page 4 Monday, August 11, 2014 4:39 PM