Motorola MTM800 FuG ET, Базовое руководство по обслуживанию

Страница: 45 / 120

Test Setup & Testing for 380–430 MHz 5.1 - 7
7. Press the “More” soft key if the Type cannot be seen.
Note: If the required Mobile soft key in step 6 and step 7 is not displayed, the
system needs to be set up manually as in step 8. If the MS type was chosen
in step 6 and step 7, continue with step 9.
8. Perform the following steps to setup the system parameters:
a. Press the “More” soft key until the “User defined” soft key is displayed.
b. Press the “User Defined” soft key in the next Menu again.
c. Press the “User Defined” soft key once more.
d. Press the “Frequency Band” soft key and press the “3 (300 MHz)” soft key. Press
the “More” soft key if the band is not displayed.
e. Press the “Offset” soft key and press the “0 (0 kHz)” soft key.
f. Press the “Duplex Spacing” soft key and press the “0 (10 MHz)” for 380
–
430 MHz
soft key
g. Press the “Reverse Operation” soft key and press the “0 (Normal)” soft key.
h. Press the “Channel Block 1" soft key.
i. Press the “Channel Block” soft key and press the “Include” soft key.
j. Press the “Lowest Channel” soft key and enter “0000” for 380
–
430 MHz using the
data keys followed by the “Lowest Channel” soft key.
k. Press the “Highest Channel” soft key and enter “4000” for 380
–
430 MHz using
the data keys followed by the “Highest Channel” soft key.
l. Press the “Lowest Tx Freq” soft key and enter “380.125” for 380
–
430 MHz using
the data keys followed by the “MHz” key.
m.Press the “Duplex Offset” soft key and enter “10” for 380
–
430 MHz using the data
keys followed by the “MHz” key.
n. Press the “Channel Spacing” soft key and enter “25” using the data keys followed
by the “kHz” key.
o. Press the “Return” soft key.
p. Verify that channel block 2 to 8 are excluded.
q. Press the “Return” soft key.
9. Press the “Control Channel” soft key and enter “3605” for 380
–
430 MHz using the
data keys followed by the “Control Channel” soft key.
10. Press the “Traffic Channel” soft key and enter “3605” for 380
–
430 MHz using the data
keys. Press the “Traffic Channel” soft key again and check that the marker goes to
Timeslot. Press data key “3” followed by the “Traffic Channel” soft key, to change to
Timeslot “3”.
11. Press the “Country Code” soft key.
Enter “234” and press the “Country Code” soft key.
12. Press the “Network Code” soft key.
Thereafter, enter “2392” and press the “Network Code” soft key.
13. Press the “Base Color” soft key.
Thereafter, enter “1” and press the “Base Color” soft key.