Motorola MTM800 FuG ET, Базовое руководство по обслуживанию

Страница: 31 / 120

Model Information & Accessories 2 - 7
Antenna Mount Panel/Roof thickness up to 4mm GMLN4276A X X X X X X
Antenna Mount Panel/Roof thickness up to 6mm GMLN4277A X X X X X X
Antenna Mount Magnetic GMLN4278A X X X X X X
Antenna Whip Tetra Flexible Hinged 380 – 400 MHz GMAE4279A X X X X X X
Antenna Whip Tetra Flexible Hinged 410 – 430 MHz GMAE4280A X X X X X X
Antenna Whip Tetra Flexible Hinged 380 – 430 MHz GMAE4281A X X X X X X
Antenna Whip Tetra Hinged 380 – 400 MHz GMAE4282A X X X X X X
Antenna Whip Tetra Hinged 410 – 430 MHz GMAE4283A X X X X X X
Antenna Whip Tetra Hinged 380 – 430 MHz GMAE4284A X X X X X X
GPS Part Number M1 M2 M3 M4 M5 M6
GPS Adaptor PMKN4114 X X X X X
a. The cable, PMKN4104, is only compatible when an Data Expansion Head Enhanced is not fitted as part of a remote mount
configuration. In this configuration, access to the Tetra PEI for IP Packet Data and SDS services is available on the Data Expansion
Head Enhanced, and the Active Data Cable PMKN4104 is not required.
b. The Handset Speaker Microphone (HSM) can offer better suppression to chopper noise by switching the steel grounding clip inside
the control head with the correspondent golden grounding clip; see footnotes c and d. For details on how to make this switch, refer
to the related instruction leaflet.
c. The golden grounding clip used in this model is 4216931H01. See footnote b.
d. The golden grounding clip used in this model is 4216932H01. See footnote b.
e. Requires Junction Box, GMLN5089.
f. Currently the GCAI handset has insufficient margin to EMC requirements and may require additional protection to pass. Additional
protection can in most cases be provided by the car body and by planning to installation such that strong coupling from other
electrical and electronic installation in the vehicle are avoided. In cases where further EMC protection is needed this can be
achieved by installing (P/N: 01015001001) as shown in kit leaflet.
The specific configuration can be tested using the following technique:
The test requires a second radio in a quiet place or cooperation with a dispatcher.
i. Ensure that all other electrical and electronic equipment in the vehicle that may cause interference are not active.
ii. Then check all intended RX and TX audio paths of the radio installation one at a time.
iii. Listen to the idle channel noise and make sure there is no obvious noise or disturbance that can be attributed to radiated or
magnetically coupled interference. Speech must be clear over the channel.
g. Keep the GCAI connector cover supplied with the new Control Head.
ACCESSORIES