Motorola MTC100 TETRA, Руководство пользователя по функциям

Страница: 24 / 80

20
Unloop the stylus tether (see Figure 9) from the metal bar by wid-
ening (opening up) the end of the loop by the metal bar then
passing the entire tether and stylus (see Figure 8) through the
open loop. Keep the bar and its screws safely.
2. Now fit the stylus tether end onto the plastic clip mounting plate
(2). Do this by passing the end of the stylus tether through the
rectangular raised opening of the mounting plate (3) from above.
Next pass the stylus and tether through the eye of the tether and
draw it closed until the tether loop is tight around the top edge of
the rectangular opening in the belt clip plate.
3. Place the plate over the four brass bolt holes on the case rear.
Screw it into place using two long bolts for the top two screws
and two shorter bolts for the lower two.
4. Click the belt clip (4) into place on the circular raised hollow boss
of the mounting plate.
5. Refit the stylus into the slot in the PDA.
9 Installing Carry Strap
1. If the carry strap mounting bar (see Figure 9) is already fitted to
the PDA, go to step 2. If carry strap mounting bar (strap attach-
ment 1) has been removed or is not fitted, fit this now to the
case rear on the top two brass mounting holes, using two
screws provided.
2. Take the Velcro strap with the rough (side with Velcro pad on)
side uppermost. Feed the end which has the Velcro pad on (that
is opposite end to the one with the metal bar attached) through
the slot in the carry strap mounting bar on the rear of the PDA
from underneath. Then draw the strap end through the slot for
about 5cm.