Chapter 2. Initialization and Setup
2-7
MPC564EVB Jumper and Switch Setup
Figure 2-3 on the next page shows the jumper locations for the board.
removed
SWITCH1 is for user use
B_RX
*insterted
CAN: see Section 1.4.2, “CAN PORTs and Options
removed
CAN: see Section 1.4.2, “CAN PORTs and Options
C_TX
inserted
CAN: see Section 1.4.2, “CAN PORTs and Options
*removed
CAN: see Section 1.4.2, “CAN PORTs and Options
C_RX
inserted
CAN: see Section 1.4.2, “CAN PORTs and Options
*removed
CAN: see Section 1.4.2, “CAN PORTs and Options
100_IRQ
*inserted
Ties the interrupt line from the Ethernet chip to
the interrupt line of the processor
removed
Disconnects the interrupt line from the ethernet chip to the
interrupt line of the processor
“ON”
* insterted
Allows the board to have power.
removed
Power to the board should be controlled by an ignition switch
connected to the IGN input on the Power Clamp, TB1.
Table 2-2. Jumper Settings (Continued)
Jumper Setting
Function
Содержание MPC564EVB
