Motorola MPC564EVB, Руководство пользователя

Страница: 12 / 98

1-2 MPC564EVB User’s Manual
•Memory Devices:
512K Byte (128K x 32) Sync. SRAM, optional additional 512K Byte
2M Byte (512K x 32) Sync. FLASH
512K Byte FLASH internal to MPC564 device
32K Byte SRAM internal to MPC564 device
•POWER OAK (PC33394 P2.6) regulated power supply for 5V, 3.3V and 2.6V supplies.
•MAP Switch – provides easy assignment of chip selects and memory mapping.
•CONFIG Switch – Basic necessary Reset Word Configuration options.
•COM1 - SCIA1 with RS232 type DB9-S Connection
•COM2 - SCIA2 with RS232 type DB9-S Connection, TX / RX polarity option.
•CAN Ports
1
– 3 CAN transceiver interfaced ports, 1 x 4 headers.
•10/100T Ethernet Port – LAN91C111 based MAC+PHY, memory mapped.
•DEVELOPMENT Ports – Nexus 50 pin and dual voltage BDM Port.
•LCD Port - LCD Module Interface Connector w/ Contrast Adjust, Buffered and Memory
Mapped
•KEYPAD Port
1
- 16 Key passive interface, applies QADC_B channels for operation.
•BUS Port – 32 data and 24 address lines on 60 pin header.
•CONTROL Port - Bus Controls with 40 pin header.
•QSM Port – Serial I/O port with 16 pin socket header.
•MIOS Port - MDA, PWM, and MGPIO ports with 34 pin socket header.
•TPU Ports
1
- 2 Timing Processor I/O ports with 20 pin socket headers.
•QADC Ports
1
- 2 Analog I/O ports, one 20 pin and one 24 pin socket header.
•IRQ Port – Interrupt or MPC564 port I/O with 10 pin socket header.
•POWER Port – Primary and standby power supply access port, no header.
•I/O Connectors in .1 grid, pin headers for bus and control provide easy ribbon cable connection
for external connections. Socket headers provide easy wire connection to breadboard prototype
area with 22ga solid wire.
•Large Prototyping Area with +5V and ground connection grids.
•Mictor Logic Probe connectors for the Address and Data bus (Not installed default)
•Breadboard Prototyping area (2.5 x 1.5 inch) for easy installation of test connections.
•System Indicators – Reset Indicator, Supply voltage indications for 5V, 3.3V, and 2.6V supplies
•Reset Switches – POReset, Hard, Soft reset buttons.
•User Components – 4 user LEDs (one with debounce), 4 user Switches, 1 user Potentiometer
with socket header for I/O connection.
1
The MPC533/4 has limited or no functionality for this module. See Appendix A