Motorola BSR 2000, Руководство по установке

Страница: 37 / 74

Performing Installation Tasks
526359-001 MGBI 2-15
1. Identify the upstream channel number of each cable. For this example, the cables
associated with upstream channels 1 and 2 (US1 and US2 respectively).
2. Match each upstream cable with its channel connector on the BSR 2000 rear
panel.
The ports are color-coded with blue labels.
3. Insert the center conductor of each upstream channel cable into the small opening
at the center of the BSR 2000 upstream channel connector associated with the
cable.
4. Secure the connection by screwing the outside cable connector housing onto the
BSR 2000 upstream connector until finger tight; then, using a wrench, tighten the
connector one-quarter turn (15 in.-lbs when using a torque wrench).
Figure 2-10 Connecting Upstream and Downstream Cables to the BSR 2000 Rear Panel
Connecting a Coaxial Cable to the Wireless Port
The BSR 2000 features a wireless port, to provide IF output, on the rear panel. The
port is color-coded with a green label.To connect a cable to the wireless port, follow
these steps and refer to
Figure 2-11 .
1. Unscrew and remove the metal terminator cap from the IF connector.
The metal terminator cap comes factory-installed. Save the terminator cap, just in
case you need to use it again in the future.
US2 US1 US0 DS0 IF
Downstream
coaxial cable Upstream
coaxial cables
bsr2k006