Motorisation+ FULL24, Инструкции и предупреждения по установке и использованию

Страница: 24 / 44

EN
24
Turn off the power supply.
With the help of a screwdriver remove the lower screw (Fig.13a).
Remove the cover and the LED strip (Fig.13a).
Disconnect the connector (Fig.13b).
4.9 - Replacement of the leds - 24 Vdc
Connect the new LEDs and insert them into the mask.
Insert the mask first inserting the side of the seal and then securing
it with the screw.
COM PAR OPEN CLOSE SBS NEG PH-POW PH1 PH2 COM FLASH LED SEN COM STOP EDGE EDGE COM ELEC COM IND
POWER SUPPLY
N
T2A
L
230Vac 50/60Hz
PHOTOTEST
LIGHT
TWILIGHT SENSOR
LED OUTPUT
STOP OPEN
PHOTOCELL 1 PHOTOCELL 2
CLOSE
PARCIAL
STEP BY STEP
+ COMMON + COMMON
SAFETY EDGE
ELECTRIC LOCK
NEGATIVE
SBS
M1
M2
BATTERIES (ACCESSORY)
COMMON
FLASH
SHIELD ANT
PH1
RX
2
1
PH1
TX
SHIELD ANT COMMON FLASH
4.10 - Electrical connections
TRANSFORMER
WARNING - Before making the connections, ensure that the control unit is not powered up.
POWER SUPPLY CONNECTIONS
L Power supply 230 Vac 50-60 Hz
Earth
N Power supply neutral 230 Vac 50-60 Hz
M2 M2 M1 M1