MotorGuide Digital Steering, Инструкция пользователя, Страница: 15 / 22

90-MM6900
13
Adjusting the Foot Pedal Resistance
Do not adjust ball detent screws. They are
factory adjusted to give maximum feel to the
pedal center position.
The purpose of setting the pedal resistance is to make the
pedal feel comfortable for you. You may adjust the clutch
mechanism to change how firm the pedal feels. The pedal
resistance can be adjusted using a Phillips screwdriver
and a (13 mm) 1/2 inch wrench. To make this adjustment,
place the foot pedal in the heel-down position. Tighten or
loosen the adjustment nut. Your foot pedal should operate
smoothly without binding or slipping.
The foot pedal has a center position stop that you can feel
while rocking it from end to end (heel down to toe down
and visa versa). This is done with the Ball Detent screws
shown in the above figure. The Ball Detent screws are
factory set to give maximum pressure to this feature and
are not intended for readjustment.
Foot Pedal Calibration
The foot pedal was initially calibrated at the factory.
Recalibrate your foot pedal if you:
•
Notice you are not getting a full 400-degree steering
rotation.
•
Have installed a new pedal on your motor.
•
Have moved the trolling motor installation from one
side of the boat to the other.
Foot pedal calibration will maximize steering control at
high speeds.
To Calibrate a New Foot Pedal:
1) Put the motor in the run position.
2) Press the Constant-On and Momentary buttons
simultaneously. Hold both buttons down for three
seconds. (You will notice the motor turn to the center
position and start making a clicking noise in the
head.)
3) Push the pedal forward to the toe-down position and
press the Momentary button.
4) Move the pedal to the center detent position and
press the Momentary button again.
5) Move the pedal to the heel-down position and press
the Momentary button.
The calibration for the foot pedal is now complete and the
clicking will stop. The motor should now steer in
accordance with the pedal movement.
Adjustment Nut
Ball Detent Screws –
Do Not Adjust
CAUTION