Motor City Wash Works MINI WRAP, Руководство по установке

Страница: 26 / 35

© Motor City Wash Works, Inc. 48285 Frank, Wixom Michigan 48393 U.S.A.
Phone: 248.313.0272 ▪ Fax: 248. 313.0271
8MANULWRPINS002 12-11-2020
www.motorcitywashworks.com 26

Run a car through the wash and verify proper operation of both WRAP WHEELS:

Confirm wheel speed under vehicle load with the HYDRAULIC POWER UNIT SET AT 1000 PSI.
Open the hydraulic flow control valve or increase the hydraulic power unit pressure as needed to
reach recommended speed value previously specified.
DO NOT EXCEED 1250 PSI AT THE
HYDRAULIC UNIT!

Confirm that both arms are MOVING around the front of the vehicle.

Confirm that both SECONDARY ARMS are turning the rear corner of the vehicle properly in order
to clean the REAR OF THE VEHICLE.
WARNING
!
FOR AN ELECTRIC DRIVE MINIWRAP™, TURN OFF EACH
OVERLOAD RELAY, ONE AT A TIME, AND CONFIRM THAT
THE CONVEYOR STOPS OR THAT THE WRAP AROUND ARM RETRACTS.
FAILURE TO DO SO MAY LEAD TO MAJOR EQUIPMENT
DAMAGE IF ONE OF THE TWO WRAP MOTOR OVERLOAD RELAYS
TRIPS OR MALFUNCTIONS!
Maintenance:
DAILY:

Check for hydraulic leaks, chaffed hoses electrical cable, etc.

Visually inspect for any signs of wear.

Move the arms manually and duplicate its regular motion and look for abnormalities: A loose fastener may
allow some parts to move or rub and may create a dark stain running down the equipment.

Start the day with a TEST WASH and check for proper operation.

While you are watching the TEST WASH, check for clogged nozzles. If a nozzle is clogged, remove the
nozzle body and clean the nozzle by inserting a small piece of wire (a small paper clip wire will do fine!) in
the nozzle opening.

Check for proper coverage of the two Streamer™ Foamers if applicable.

Check for the overall performance of the equipment on the vehicle: Profiling, cleaning, etc.

Wash down your equipment and the surrounding area at the end of each day.
MONTHLY:
Each piece of MCWW equipment is assembled with the highest quality bearings which have been factory pre-
lubricated, therefore it does not require supplemental grease for at least the first month of operation.
Use any lithium-based NLGI #2 grease (ex: Exxon Mobil MOBILITH AW2).
WARNING
!
OVERLUBRICATION IS A MAJOR CAUSE OF BEARING FAILURES!
LUBRICATE CONSERVATIVELY!