7
11.1 Clock
Menu „hour“ provides the clock time in 24 hour format. Condition is the connection of the
motoscope tiny’s red cable to cont12V. This cable must fuse with a 5A fuse.
11.2 Odometer (km or ml)
The odometer shows the amount of kilometres or miles since starting the instrument. This value
can be adjusted or set to zero the setup menu’s level „SET ODO“.
11.3 Trip counter (km or ml)
The current trip milage is displayed in menu „Trip“. The trip counter differ form the odometer by a
decimal place. The milage is shown between 0 – 999.9 km or ml. After reaching the 999.9 the
counter starts again from 0. To reset the trip value, hold the menu button until the display sets to
zero.
11.4 Maximum speed (km/h or mph)
The maximal reached speed is displayed in menu „Top Speed“. The reset the value, hold the push
button until the display sets to zero.
11.5 On-board voltage
The on-board voltage is displayed in menu “batt”.
12 Setup
All operations, adjustments, and calibrations of the motoscope tiny are carried out using a single
pushbutton. For this reason the internal design of the setup is laid out in logical levels. The
selection of and access to these levels as well as to their sub-points is controlled using different
button compression times. The different times are represented visually by the illumination of the
first two indicator lights.
In order to enter the setup menu the pushbutton has to be engaged until "Setup" appears in the
display. Now a short push button operation (one indicator light is illuminated) will navigate trough
the setup main menu. Al long push button operation (two indicator light are illuminated) will activate
the displayed menu. The setup operation overview is shown in chapter 15.3.
12.1 Menu 1 – Clock setup (SET hour)
A short push button operation (one indicator light is illuminated) increases hour or minute. A long
push button operation (two indicator lights are illuminated) change between hour and minute setup.
If the push button is hold for some seconds, the display will be switch back to the setup main
menu.
12.2 Menu 2 – Odometer setup (SET ODO)
If you like to take the vehicles milage form the old speedometer to the motoscope tiny you can
setup this value. A short push button operation (one indicator light is illuminated) increases the
chosen digit. . A long push button operation (two indicator lights are illuminated) change between
the digits. If the push button is hold for some seconds, the display will be switch back to the setup
main menu.
12.3 Menu 3 – Set impulse per wheel revolution (SET PULSE)
In this menu you can set the amount of speedometer senor impulses per wheel revolution. There is
no need for adjustments if using the motogadget speedometer senor with one magnet. If you use
more than one magnet the amount of magnets has to be adjusted. If using an OEM speedometer
sensor, set the amount auf output pulses per wheel revolution. A short push button operation (one
indicator light is illuminated) increases the chosen digit. A long push button operation (two indicator
lights are illuminated) change between the digits.
