MOTO GUZZI V9 Bobber 2016, Руководство пользователя

Страница: 35 / 126

02_33
02_34
User Code Modification "Change user code"
The user code enables engine start even in the event of an immobiliser system fault.
The user code is set by default as five zeros (00000) on a new vehicle, and the mes-
sage "INSERT YOUR PERSONAL CODE" is shown on the display for ten seconds.
The "USER CODE MODIFICATION" function may be used to change the code and
stop the message from being displayed. The value displayed for the figure on the
furthest left hand side of the LCD cycles between 0 and 9. Press the centre of the
"MODE" selector briefly to confirm each of the five figures. Once the code is confirmed,
the new code is shown steadily on the display to let the user verify that the code has
been entered correctly. Turn the ignition off and then on again to unlock the instrument
panel.
The last code set may be modified again in future. Access the setting mode again,
enter the last user code used (OLD CODE), then enter a new user code (NEW CODE)
as described previously.
02_35
User Code Recovery "Recover user code"
This function must be used should it be necessary to change the user code when the
user no longer remembers the current code. Both keys stored in the vehicle memory
are needed to access this function.
Press and hold the "MODE" to activate the function. The message "INSERT KEY 1"
is shown on the display, requesting identification of the first key. Insert the key. If the
correct key is recognised within twenty seconds, the message "INSERT KEY 2" is
shown on the display. Insert the second key. If the second key is also recognised
within twenty seconds, the instrument panel resets the user code to the default code
(five zeros - 00000). Enter the new user code following the "SET CODE MODIFICA-
TION" procedure.
35
2 Vehicle