MOTO GUZZI Stelvio 1200 4V, Руководство по обслуживанию станции

Страница: 112 / 135

•
Turn on the scanner.
•
Screw the joints connecting the vacu-
ometer pipes on the inlet pipe holes.
•
Connect the vacuometer pipes to the
relative joints.
•
Set the key to ON.
•
Make sure there are no errors in the
control unit; otherwise, solve them and
repeat the procedure.
•
Make sure the left throttle is fully in.
DO NOT TOUCH THE THROTTLE ABUTMENT
SCREW OR THE THROTTLE BODY MUST BE
REPLACED. CHECK THAT THE THROTTLE
RETURN CABLE IS NOT TAUT.
•
The Axone should display the adjustable parameters screen.
•
Autodetect the throttle position.
•
Turn the key to "OFF" and leave it for
at least 30 seconds.
•
Turn the key back to "ON" and restore
the Axone session.
•
Check that the "Throttle" value reading
is 4.7 +/- 0.2°. If the value is incorrect,
replace the control unit and repeat the
procedure from the start.
•
Completely close the two by-pass
screws on the throttle bodies.
•
Start the engine.
•
Take the engine to the prescribe tem-
perature: 60 °C (140 °F).
•
Make the engine rev at 2000/3000 rpm
and with the vacuometer check that the
difference between the two pressures
is maximum 1 cm Hg (1.33 kPa).
If this condition is detected:
Power supply
STELVIO 4V - 1200
P SUPP - 4