
Specification
Desc./Quantity
Lambda Probe
300 - 3000 mV (approximate values).
Signal when energised that the control unit receives from the
lambda probe: inversely proportional to the presence of oxy-
gen.
Lambda integrator
When the control unit uses the lambda probe signal (see the
'Lambda' parameter on the 'Device status' display) this value
should be close to 0%
Partial load self-adjustment
Supplementary correction factor for the injection time, in out-
of-idle condition.
Idle check self-adjustment
Supplementary correction factor for the injection time, in idle
condition.
Rich multiplicative correction
Multiplicative correction factor for the injection time.
Not synchronised timing of a tooth
Number of engine timing steps during which the revolution tim-
ing sensor has lost the signal of a tooth.
Higher not synchronised timing of a tooth
Number of engine timing steps during which the revolution tim-
ing sensor has lost the signal of more than one tooth.
Engine rpm
Engine revolutions per minute: the minimum value is set by the
control unit cannot be adjusted
Injection time
- ms
Ignition advance
- °
Atmospheric pressure
1015 mPa (approximate values)
The sensor is inside the instrument panel
Air temperature
°C
Temperature of the air taken in by the engine, measured by the
sensor in the filter casing. This is not the temperature indicated
by the instrument panel
Engine temperature
°C
Battery voltage
V
Device status screen page
DEVICE STATUS
This screen page shows the status (usually ON/
OFF) of the vehicle devices or the operation con-
dition of some vehicle systems (for example, lamb-
da probe functioning status).
D
EVICE
STATUS
Specification
Desc./Quantity
Engine status
ON/run/power-latch/stopped
operation conditions
RPM sensor
Synchronised / Not synchronised.
Throttle position
Released / pressed
indicates if the throttle potentiometer is open or closed
Lambda
Open loop / Closed loop
Indicates if the control unit is using (CLOSED) the lambda
probe signal to keep the stoichiometric combustion. At idle
CLOSED only if: Air T over 20°C (68°F) and engine T over 30°
C (86°F) and engine on for at least 2-3 minutes
NEVADA 750
Power supply
P SUPP - 79
Содержание NEVADA 750
