Motion Composites MOVE, Руководство пользователя, Страница: 10 / 24

T (450) 588-6555 - 1 866 650-6555 F (450) 588-0200
info@motioncomposites.com
10
9.3 Front Riggings
9.3.1 Installing
• Insert the front rigging pivot into the wheelchair’s mounting
tube.
• Rotate the assembly toward the front until the mechanism
locks into place.
• Repeat the same steps for the other side.
9.3.2 Uninstalling
• Push the release locking lever (1) (Fig. 4) inward and maintain
that position so the front riggings can rotate freely.
• Rotate front riggings outwards to disengage the locking
mechanism.
• Lift the assembly up so as to disconnect it from the
wheelchair’s frame.
• Repeat this procedure for the other side.
Fig. 4
9.4 Footrest
• When transferring, avoid putting weight on the footrest and be
careful not to stand behind the footrest.
• Never use footplates to lift the wheelchair.
• Only use non-detachable parts to lift the wheelchair.
9.4.1 Elevating legrest
9.4.1.1 Installing the elevating legrest
• Remove the actual footrest, see section 9.3.2
• Install the elevating legrest (Fig. 4.1) the same way to install a
regular front rigging, see section 9.3.1.
9.4.1.2 Adjusting the elevating legrest
• To change the legrest length, pull on the lever (1) to open the clamp
• Change the length and push on the lever (1) to close the clamp.
• To change the legrest angle, set the desired angle while pushing
on the red button (2).
2
1
Fig. 4.1
9.5 Armrests
Ensure that armrests are securely locked into arm
sockets and armrest release buttons are locked into
place prior to using the wheelchair.
• Never lift the wheelchair by holding the armrests.
• Use only non-detachable parts for lifting.
9.5.1 Flip-back armrests
To lift the armrests:
• Pull lever (1) (Fig. 5) upwards to
release the system.
• Rotate the armrest all the way
up and down.
To reinstall the armrests in closed
position:
• Rotate the armrests downward
until the front slide plate enters
in the armrest receiver and
snaps into place.
• Make sure the locking lever is
engaged to avoid any movement.
Fig. 5
9.5.2 Removable T armrests
To remove the armrests:
• Pull lever (1) (Fig. 6) upwards to release the system.
• Pull the armrest all the way up.
To reinstall the armrests:
• Bring the armrests downward until the slide (3) enters in the
armrest receiver (4) and snaps into place.
• Make sure locking lever (2) is engaged to avoid any
movement.
Fig. 6