T
(450) 588-6555 - 1 866 650-6555
F
(450) 588-0200
10
If you ignore these Warnings or fail to inspect or maintain your
wheelchair as directed in the manual , you may fall, tip over or lose
control of the wheelchair and seriously injure yourself or others or
damage the wheelchair.
8.2.5
Reaching/Leaning/Bending
The balance point may shift when you are putting on
clothes and/or reaching for objects while sitting in the
wheelchair.
If at all possible, use a reaching device
or ask for assistance when reaching for
objects.
Move the wheelchair as close as possible
to the required object. Rotate the casters
as far forward as possible from the rear
wheels.
NEVER
reach for objects between your
legs, but rather position yourself to the side
of these objects. Do no shift your weight
sideways, but rather rise up from the seat
or move forward in the seat. Always use
both hands and grab the opposite side
wheel or armrest if you are capable of
reaching sideways. Never reach to the rear of the wheelchair
unless it is equipped with anti-tippers Never reach for objects
over the seat back: reach only as far as your arm naturally
extends without moving on the seat.
DO NOT
lock the rear wheels if you are reaching backwards.
Avoid putting pressure on the footrests.
8.2.6
Moving backwards
Lock anti-tippers in lower position. Move slowly: the wheelchair
is designed to provide you with more stability when moving
forward. Look around as often as possible to avoid obstacles
in your path.
8.2.7
Ramps, Slopes & Side Hills
Ramps of 10 feet (3 meters) or less in length:
If you need to use a short ramp 10 feet (3
meters) or less, the angle of the slope should
not exceed 10 degrees, which corresponds to
a slope of 17.63%, a rise of 1.74 feet (0.53
meters) over a distance of 10 feet (3 meters).
Make sure to be assisted by a caregiver who has the physical
ability to retain the wheelchair and its occupant. The wheelchair
must always point facing up the slope.
The caregiver should always remain in the
bottom of the slope to retain the wheelchair.
Always lock the anti-tip in the safe position.
Follow the same words of caution for a hill or a
slope of 10% or less.
DO NOT
use your wheelchair on a ramp under
3 meters in length if the slope angle is greater than 10 degrees
(17.63%).
Ramps of 10 feet (3 meters) or more in length:
If you must go through a slope or a vertical rise of 10 feet (3
meters) or more, the angle of the slope should not exceed 5.7
degrees, which corresponds to a 10% slope is a rise of 1 meter
for a distance of 10 meters.
Make sure to be assisted by a caregiver if you have trouble on
the slope or if the slope is between 5.7 and 10 degrees.
Try to move straight up or down the slope. Avoid turning on a
downhill slope.
Stay in the center of sidewalks and ensure that there is enough
space for the wheels.
Avoid stopping on slopes and never use the wheel locks to slow
yourself on a downhill slope. Maintain your speed by holding the
hand rims.
DO NOT
ride on wet or slippery surfaces. Be cautious for
changes in terrain height or stairs at the end of a slope (front
casters may lock from simply hitting a small bump).
Ask for help should any situations arise.
Incline yourself while moving down a slope as to adjust your
center of gravity.
DO NOT
use your wheelchair on your own on slopes or hill of
more than 10 feet (3 meters) in length if the angle of the slope
is greater than 5.7 degrees (10%).
8.2.8
Obstacles
Always look for obstacles or road hazards (potholes, broken
surfaces, etc.). Clear your own environment (work, home)
of any obstacles. Never use objects (furniture, ramps, and
doorknobs) to push yourself out of the wheelchair.
Lean your upper body slightly forward as you move up an
obstacle. Do the reverse while moving down an obstacle. Keep
both hands on the hand rims while passing over the obstacle.
