Motic 1100200600841, Инструкция по эксплуатации

Страница: 27 / 33

26
8. CAMERA AND VIDEO EQUIPMENT INSTALLATION
8.1 Camera installation and use

The camera equipment includes a camera port, a camera adapter and a camera. Among which,
the camera port is supplied by Motic while the adapter and camera may be purchased elsewhere.

Once the microscope has been assembled, loosen the holding screw on the camera/ video port
and remove the cap. Next, insert the camera and adapter into the port.

After focusing the microscope, pull out the beam splitter on the backside of the main body. Next,
adjust the height of the camera until a clear image is observed through the camera [You may need
to rotate the camera until the image achieves similar direction.]. At this point, tighten the holding
screws you loosened in the second step.
8.2 Video installation and use
The video device includes a video camera, a c-mount camera adapter and a camera port. Among which,
the camera port is supplied by Motic while a video camera may be purchased elsewhere. Purchase the
appropriate c-mount camera adapter (0.5X for 1/3”, 0.65X for 1/2” or 1X for 2/3”) from Motic according
to the size of the camera’s chip sensor.

Connect the c-mount camera adapter to the camera (Note: the video adapter and camera can be
either a CS or C mount type, make sure they are both the same).

Loosen the holding screw on the camera/video port, remove the cap, insert the video camera and
tighten the holding screw. Next, connect the export terminal of the video camera to the video input
terminal of the monitor.

After focusing the microscope, pull out the beam splitter on the backside of the main body and
adjust the video camera until a clear and focused image is gained.