Motak PKM0335, Инструкция по установке и эксплуатации

Страница: 5 / 137

DANGER
͹ Do not operate equipment that has been misused, abused, neglected, damaged, or
altered/modified from that of original manufactured specifications. This appliance is
not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given
supervision concerning use of the appliance by a person responsible for their safety.
Do not allow children to play with, clean or maintain this appliance without proper
supervision.
͹ It is the responsibility of the equipment owner to perform a Personal Protective
Equipment Hazard Assessment to ensure adequate protection during maintenance
procedures.
͹ The on-site supervisor is responsible for ensuring that operators are made aware of the
inherent dangers of operating this equipment.
͹ All covers and access panels must be in place and properly secured when operating this
equipment.
͹ Failure to disconnect power at the main power supply disconnect could result in serious
injury or death. The power switch DOES NOT disconnect all incoming power according
to approved practices during maintenance or servicing.
͹ Risk of fire/shock. All minimum clearances must be maintained. Do not obstruct vents
or openings.
͹
Do not store or use gasoline or other flammable vapors or liquids in the vicinity of this
or any other appliance
. Never use flammable oil soaked cloths or combustible cleaning
solutions for cleaning.
͹ All utility connections and fixtures must be maintained in accordance with the authority
having jurisdiction.
͹ Do not operate any appliance with a damaged cord or plug. All repairs must be
performed by a qualified service company.
͹ Never use a high-pressure water jet for cleaning on the interior or exterior of this unit.
Do not use power cleaning equipment, steel wool, scrapers or wire brushes on stainless
steel or painted surfaces.
͹ Two or more people are required to move this equipment to prevent tipping.
͹ Locking the front casters after moving is the owner’s and operator’s responsibility.
When casters are installed, the mass of this unit will allow it to move uncontrolled on
an inclined surface. These units must be tethered/secured to comply with all applicable
codes. Swivel casters must be mounted on the front and rigid casters must be mounted
on the rear. Lock the front casters after installation is complete.
͹ All replacement parts must be like components obtained from the equipment
manufacturer’s authorized replacement part network.