Mosa DSP 500 PS, Руководство по эксплуатации и обслуживанию

Страница: 31 / 54

ACCESSORY USE (DSP/C S SERIES)
REMOTE CONTROL
RC2
RC2/90°
M
38.10
REV.3-12/11
The remote control RC, which regulates the welding
current in the CC (STICK welding) mode and the
welding voltage in the CV (MIG/MAG welding), is
connected to the front panel by means of a multipole
connector.
When the remote control is connected to the remote
control connector (8), it is functional and automati-
cally excludes the front panel regulation. The remote
control can also be connected to the connector on
the wire feeder front panel but in this case it is ne-
cessary to switch the wire feeder commutator so it
can operate.
Adjust the welding current control knob to the cor-
rect current for the diameter and type of electrode
being welded.
PUSH AND
SCREW TIGHT
09/04/02 M38GB
ATTENTION
When the RC is not used, it is necessary to disconnect the
multipole connector
!
PUSH AND
SCREW TIGHT