
REMOTE CONTROL
See page M 38
This symbol (Norm EN 60974-1 security
standards for arc welders) signifies that the
welder can be used in areas with increased
risk of electrical shock.
M
34
REV.0-01/16
07/01/16 C0QB301
1_01-16_EN
USE AS WELDER
Check at the beginning of any work the electric
parameters and/or the control placed on the front.
Make sure that the ground connection (12) is efficent
(when this connection is present, being necessary).
See page M20.
Fully insert the welding cable plugs into the corre-
sponding sockets turning them clockwise to lock
them in position.
Make sure that the ground clamp, whose cable
must be connected to the + or - terminal, de-
pending on the type of electrode, makes a good
connection and is near to the welding position.
Pay attention to the two polarities of the welding
circuit, which must not come in electric contact
between themselves
ATTENTION
The areas, access of which is forbiden to unqua-
lified personel, are:
- the control switchboard (front) - the exhaust of
the endothermic engine - the welding process.
ATTENTION
To reduce the risk of electromagnetic interferen-
ces, use the minimum lenght of welding cables
and keep them near and down (ex. on the floor).
The welding operations must take place far from
any sensitive electronic device.Make sure that the
unit is earthed (see M20). In case the interference
should last, adapt further disposition, such as:
move the unit, use screened cables, line filters,
screen the entire work area.
In case the above mentioned operations are non
sufficient, please contact our Technical Assistance
Service.
CAUTION
With a
welding cable length up to 20 m is
suggested a section of 35 mm²; wìth longer
cables a bigger section is required.
!
!
!
PUSH AND
TWIST