MOSA Weld MAGIC WELD 200 YDE, Руководство по эксплуатации и обслуживанию

Страница: 22 / 36

02/10/19 C0EP2000_EN
ENGLISH
ENGLISH
M
34
USE AS WELDER
REV
.0-10/19
This symbol (Norm EN 60974-1 security standards for
arc welders) signifes that the welders can be used in
areas with increa-sed risk of electrical shock.
ATTENTION
To reduce the risk of electromagnetic interference, keep the
welding cable length short and keep them on or near the
ground. If possible, welding operations should not be done
near sensitive electronic devices. If interference continues
to occur, adopt additional measures: shift the group, use
shielded cables, line flters, shield the entire work area. If the
above solutions do not suffice,consult our Technical Servicing
Department.
!
ATTENTION
With a welding cable length up to 10 m is suggested a section
of 35 mm²; wìth longer cables a bigger section is required.
!
CONNECT WELDING CABLES
Fully insert the welding cable plugs
into the corresponding sockets
turning them clockwise to lock them
in position.
Ensure that ground clamp, whose
cable must be connected to the (-)
socket or the (+) socket, according
to the type of electrode, makes good
contact and that, if possible, it is close
to the welding position. Pay attention to the two polarities of
the welding circuit, which must not come into electrical contact
with each other.
PUSH AND
TWIST
ADJUSTING THE WELDING CURRENT
The welding current is regulated by tur-
ning knob “T” continuously. If set to the
minimum (turned fully in an anticlockwise
direction) it provides a current of approxi-
mately 30 A; if set to the maximum (turned
fully in a clockwise direction) it gives a
maximum current of approximately 200A
(20V).
AUTO IDLE – ECONOMISER (only for version YDE)
Operation
When the engine is switched on it immediately reaches a ma-
ximum speed of 3720 rpm for ap-proximately 6/7 seconds for
easy start up, after which it automatically decreases and idles
at 2650 rpm. It remains at this speed until current is drawn
when set to weld or auxiliary power.When set to weld mode
the machine reaches maximum engine speed as soon as there
is minimum contact between the tip of the electrode and the
piece to be welded and also when set to generation drawing a
minimum of 250 - 300 W.
The machine returns to minimum 6/7 seconds later if power is
not drawn during welding or generation.
ATTENTION
It is prohibited for any unauthorized persons to
access areas adjacent to the engine driven welder
or the welding process.
!
22