MOSA Weld MAGIC WELD 200 YDE, Руководство по эксплуатации и обслуживанию

Страница: 20 / 36

02/10/19 C0EP2000_EN
ENGLISH
ENGLISH
+
Before stopping the engine it is compulsory to stop the
load:
- stop welding;
- shut off any loads which are connected to the unit auxiliary
outputs.
RECOIL VERSION
Let the motor run at no load for several minutes
to allow for cooling and then move the accele-
rator control into the “STOP” position.
ELECTRIC STARTING
Wait for the motor to automatically go to the minimum RPM, 6/7
seconds after load release, leave the motor
running under these conditions for several
minutes in order to allow for cooling, then
turn the starting key to the “OFF” position.
OFF
ON
START
Shut the fuel cock.
+
NB.: or safety purposes remove the starter key from the
machine at the end of every work session.
M
22
STOPPING
REV
.0-10/19
ATTENTION
To switch off the motor in case of emergency, either move
the accelerator control to the “STOP” position immediately
or move the starter key to the “OFF” position.
!
20