GENERAL CARE
xiii
Precautions
•
Turn off the device before inspecting or cleaning.
•
Do not immerse the device in water.
•
Do not use organic solvents, ammonia-based solutions, or abrasive cleaning agents which may damage
equipment surfaces.
Inspection
Inspect your equipment daily prior to operation. If you notice anything that requires repair, contact an authorized
service person to make the repairs.
•
Verify that all cords and connectors are securely seated.
•
Check the case and chassis for any visible damage.
•
Inspect cords and connectors for any visible damage.
•
Inspect keys and controls for proper function and appearance.
Cleaning Exterior Surfaces and Patient Cable
1.
Remove cables and lead wires from device before cleaning.
2.
For general cleaning of cables and lead wires, use a soft, lint-free cloth lightly moistened with a mild soap
and water solution. Wipe and air dry.
3.
For disinfecting the cables and lead wires, wipe exterior with a soft, lint-free cloth using a solution of
Sodium Hypochlorite (10% household bleach and water solution) minimum 1:500 dilution (minimum 100
ppm free chlorine) and maximum 1:10 dilution as recommended by the APIC Guidelines for Selection and
Use of Disinfectants.
4.
Use caution with excess liquid as contact with metal parts may cause corrosion.
5.
Do not immerse cable ends or lead wires; immersion can cause metal corrosion.
6.
Do not use excessive drying techniques such as forced heat.
WARNING: Prevent liquid from penetrating the device and do not attempt to clean/disinfect the
device or lead wires by submerging into a liquid, autoclaving, or steam cleaning. Never expose lead wires
to strong ultra-violet radiation. Do not sterilize the device or ECG lead wires with Ethylene Oxide (EtO)
gas..
Cleaning the Device
Disconnect the power source. Clean the exterior surface of the device with a damp, soft, lint-free cloth using a
solution of mild detergent diluted in water. After washing, thoroughly dry off the device with a clean, soft cloth or
paper towel.
Cautions
Improper cleaning products and processes can damage the device, produce brittle lead wires and cables, corrode the
metal, and void the warranty. Use care and proper procedure whenever cleaning or maintaining the device.
Содержание ELI 230
