Mortara ELI 10 Rx, Руководство пользователя, Страница: 58 / 72

SECTION 6
34
If DHCP is set to NO, your wireless access point will have a static network setting and the following parameters
must be configured in the device:
IP address
Default gateway
Sub net mask
If DHCP is set to YES, your wireless access point will have an automatic network setting and IP address; default
gateway and sub net mask do not need to be configured.
In either DHCP setting, the following wireless network parameters must be provided by your IT Manager:
Host IP
Port number
SSID
Channel number
NOTE: Addresses are always entered as 4 sets of 3 digits; therefore, an address of 192.168.0.7 must be
entered on the device as 192.168.000.007.
If WEP security is disabled on your access point, then set security (WEP) to NO. If WEP security is enabled on
your access point, then the following wireless network parameters must be configured in the device by the IT
Manager:
Security: WEP
WEP key
WEP key ID
NOTE: The range for the WEP key is 0-3. If the range on your access point is 1-4, then 0 at the ELI 10 Rx
maps to 1 on the access point; 1 maps to 2 on the access point, etc.
If your wireless security environment is WPA (Wi-Fi Protected Access) then you will need to enter:
Security: WPA-PSK
Passphrase:
NOTE: The passphrase length is limited to 63 characters.
Security (WEP)
WEP is an encrypted security protocol (part of the 802.11 standard). Access points can have multiple WEP keys
stored. Each one of them is identified by a number (e.g., 0, 1, 2, 3).
WEP Key
Enter the WEP key number.
WEP Key ID
Enter the 128-bit WEP key ID value (26 digits in 13 sets of two digits).