Mortara ELI 10 Rx, Руководство пользователя, Страница: 29 / 72

SECTION 1
5
The ELI 10 Rx features a 320 x 240 pixel LCD display for valuable preview of ECG waveform, function-key labels,
and other parameters as explained below:
Heart rate (HR):
When a patient is connected to the electrocardiograph, his/her HR is displayed in real time. The HR is the average
ventricular rate measured over the 10-second rhythm on a standard ECG. HR is displayed in the upper left corner of
the display screen.
NOTE: If a lead fault occurs, the lead name flashes in this location until fault is corrected. In the event all
leads are disconnected, “LEADS OFF” will flash until the fault is corrected.
Speed:
Use F3 (Speed) to select speed for rhythm viewing: 5 mm/s, 10 mm/s, 25 mm/s, or 50 mm/s. Speed in
millimeters per second is displayed to the right of HR.
Gain:
Use F4 (Gain) to select waveform amplitude for display: 5 mm/mV, 10 mm/mV, or 20 mm/mV. Gain is displayed
in the top center portion of the display screen to the right of speed.
Filter:
Use F5 (Filt) to select the filter setting for display and printing: 40 Hz, 150 Hz, or 300 Hz.
WARNING: When the 40 Hz filter is used, the frequency response requirement for diagnostic
ECG equipment cannot be met. The 40 Hz filter significantly reduces high-frequency components of the
ECG and pacemaker spike amplitudes, and is recommended only if high-frequency noise cannot be reduced
by proper procedures.
Battery:
Battery charge availability will be displayed in the bottom right-hand corner showing the various levels of battery
charge in increments of 25%.
ID:
Use
F1 (ID)
to enter patient ID and demographic information.
Leads:
Use F2 (Leads) to toggle between the eight initial default leads, a 3-lead view, and between leads I, II, and III;
aVR, aVL, and aVF; V1, V2, and V3; or V4, V5, and V6.
Clock:
Time display with hour, minutes, and seconds resolution. (See Section 2 for setting a new time.)