2
3
3
1.1 Unpacking the stove
1630: After removing the outer packaging, flatten it and lay onto the floor close to the stove;
this can then act as protective work surface during the assembly process.
Next, remove the legs and bolts from inside the stove. Gently lay the stove onto its back and
unscrew it from the wooden pallet. Using the bolts supplied, now screw the legs into position on
the underside of the base. The stove should now be lifted and moved into the upright position,
avoiding excess load on the back legs.
The stove is heavy and therefore it is strongly recommended that when lifting, it is undertaken
by two people. Morsø 1630 weighs 133 kg.
1.2 Installing the stove
The stove and chimney installations MUST comply to all current National and Local Building Re-
gulations; your approved Morsø dealer or your local building control officer can advise regarding
this. Ultimately, it is you and your installer who is responsible that the installation complies.
1.3 Chimney sweep
It may also be wise to consult your local chimney sweep before installing the stove. After your
stove has been installed, it is advisable to have the chimney checked and swept at least once
a year. In any case, if your chimney has not been used for some time, it should be inspected for
cracking, bird nests, etc. before it is put back into use.
1.4 Stove placement/clearance requirements
Minimum Clerarance requirements apply if the stove is placed near to combustible materials.
Permitted clearances to combustible materials are also indicated on the data plate on the rear
of the stove.
In situations where the stove is to be fitted into a brick or non-combustible recess, we recommend
that the stove is installed with at least 10 cm clearance to the wall, this will allow heat to circulate
around the stove; also the maintenance of the outside stove is easier. When applied to masonry,
a layer of wallpaper is normally classified as a non-combustible surface.
1.0 INSTALLINg yOUR MORSø STOvE
