Morsø S81 Series, Инструкция по установке и эксплуатации

Страница: 34 / 40

34
DK ENG
8. Subsequently, the secondary air supply is adjusted to the
desired level, and the optimum combustion will continue un-
til only embers are left.
Make sure that there is always enough air (oxygen) to
maintain clear, lasting flames when, and after, reducing
the amount of combustion air.
At nominal heat output, the refill interval is appoximately
1 hour.
9. A new portion of wood can be added by repeating steps
5 & 6.
The stove door should normally be opened gently the first 2-3 cm, then you should wait until
the pressure has equalised before opening the door all the way. This technique will prevent
smoke from getting out, particularly when there is a poor draugt.
The stove door should never be opened when the stove is being fired vigorously.
Refuelling on to a low fire bed
If there is insufficient burning material in the firebed to light a new fuel charge, excessive
smoke emission can occur. Refuelling must be carried out onto a sufficient quantity of glow-
ing embers and ash that the new fuel charge will ignite in a reasonable period. If there are
too few embers in the fire bed, add suitable kindling to prevent excessive smoke :
Fuel overloading
The maximum amount of fuel specified in this manual should not be exceeded, overloading
can cause excess smoke.
Operation with door left open
Operation with the door open can cause excess smoke. The appliance must not be oper-
ated with the appliance door left open except as directed in the instructions.
Once the wood has burned out, it becomes glowing charcoall. If a good layer of embers has
already formed on top of a sufficient layer of ash, the stove can keep warm for a very long
time.