5
Temperature
control
B
Plug in the iron and switch on.
Set the temperature control dial
‡
to the temperature required
B
, but don’t start ironing
immediately. If you wait a few
minutes, the iron will stabilise at
the required setting.
Your Morphy Richards iron is
fitted with a temperature
indicator light
‚
which will go on
and off while you are ironing. This
is perfectly normal as it shows
that the iron is maintaining the
heat setting you have chosen.
It is always a good idea to begin
with ‘cool’ fabrics and work up to
higher settings. An iron heats up
quicker than it cools down so
you’ll save time and electricity.
FEATURES OF YOUR
IRON
Temperature
indicator light
The indicator light shows that the
iron is warming up. When the
required temperature is reached,
the light will go out and will cycle
on-off during operation.
Dry ironing
You can use your iron as a dry
iron only. Make sure the variable
steam control
‹
is set to the ‘0’
symbol.
Any temperature setting may be
used depending on the garment.
The spray feature may be used
provided there is water in the
tank (see ‘Filling’ section). You do
not need to put any water in the
tank when dry ironing only.
Spray
C
Press the spray button
¤
and
aim the spray of water at
stubborn creases. You can do
this whilst dry ironing, providing
there is water in the tank. When
using the water spray, it may be
necessary to push the button a
few times to get the spray pump
primed.
Variable steam
Fill the iron with water as
described in ‘Filling’, and insert
the plug into the electrical
socket.
The steam output can be varied
from low to high by rotating the
variable steam control
D
.
The steam facility should only be
used on garments which are
suitable for ironing at 2 and 3 dot
settings.
Shot of steam
E
(certain models only)
Press the shot of steam button
⁄
to obtain a burst of extra
steam for ironing out creases in
heavy material such as denim
etc.
The shot of steam can be used
whilst dry ironing, providing there
is water in the tank, and the
temperature control is set within
the steam range.
Do not use shot of steam at
temperatures below the steam
range shown on the control.
Note: For optimum steam quality,
do not operate the shot more
than three times in succession.
B
C
D
E
For details of other Morphy Richards products, please see our website:
40513 rev1:RN40513 MUK Rev1 18/02/2009 11:16 Page 5
