6
Locate your steam generator horizontally on the
iron rest plate of your ironing board (if large
enough) or on a heat resistant stand at the same
height as your ironing board or below it. Always
ensure the steam generator is on a firm surface
when ironing.
WARNING: Do not use the product on a
surface which could be damaged by heat or
steam such as a worktop or a polished wood
surface.
If in doubt, contact Morphy Richards.
Remove any protective cover from the soleplate
(6)
and the base unit, if any.
Unwind and straighten the power cord
(18)
and
steam supply cord
(8)
.
Textiles and clothes should carry ironing
instructions. If not, follow the temperature guide
on the previous page, but test the temperature by
ironing the hem of the garment or similar discreet
area first.
It is advised to begin with ‘cool’ fabrics and work
up to higher settings. An iron heats up quicker
than it cools down so you’ll save time and
electricity.
If you turn the temperature dial down from a hot
setting to a cooler setting, wait until the iron
temperature has stabilised before you continue
ironing.
NOTE: Hold the steam generator main body
(16)
with both hands when handling and moving the
unit, as the water tank
(1)
is detachable.
Safe working for ironing
Before use
Unlock the iron from its storage position on top
of the steam generator main body
(16)
by
pressing and holding the iron release button
(7)
-
this unlocks the iron, enabling you to rotate the
tip of the soleplate
(6)
(in an anti-clockwise
direction) out from under the locking hook
(12)
.
Lift the iron heel
(10)
away from the rear docking
hook
(15)
.
WARNING: Never press down on the locking
column
(13)
itself to unlock it, incase the iron
is already on and the soleplate is hot.
During use, the iron may be rested on the iron
rest plate
(14)
with the soleplate tip on top of the
locking hook and the heel slotted on to the rear
docking hook.
2
If steam ironing, ensure the iron steam supply
cord
(8)
is attached into the steam cord
connection inlet
(23)
on the back of the steam
generator main body
(16)
.
The steam cord connection inlet can be found by
opening the spring-loaded steam connection
inlet cover
(24)
.
Open the spring-loaded steam connection inlet
cover and push the steam cord connector
(26)
(with the two screw heads in the casing facing
upwards) firmly into the steam cord connection
inlet until it clicks into place.
1
Using the steam generator for steam ironing
RN330009MUK Rev2_Instruction Book 11/12/2013 14:57 Page 6
