Morphy Richards JET STREAM, Инструкция по эксплуатации

Страница: 5 / 20

4 Fill the boiler, taking care that water
does not spill over. Remove any
excess water.
5 Replace the boiler filler cap by
screwing on but don’t overtighten. If
the filler cap whistles, it is not tight
enough or the filler cap has not
been positioned correctly. In this
case switch off the boiler, allow it to
cool, then reposition the filler cap
correctly.
6 Take care not to overfill if the steam
generator contains water.
Using
1 Plug in at the mains socket.
• Check to see that the steam on/off
indicator light is 'off'.
2 Press the power switch · to the
'on' position, the indicator light in
the middle of the switch will
illuminate. Ensure that the iron
temperature control
¤ is at the
correct setting for the material you
are ironing.
3 Turn the vari-steam control knob to
the mid position as shown
C
. Set
the temperature control dial ¤ to 3-
dot.
4 Allow the boiler to heat for about 4
minutes. The generator will be ready
to use for ironing when the boiler
ready indicator
„ illuminates and
the iron ready light
›
on the iron
goes off.
• During ironing, the iron ready
indicator and the boiler ready
indicator light will cycle on-off.
Textiles and clothes are supposed to
carry ironing instructions. If they
don’t you should follow the fabric
guide on the control dial of the iron,
be sure to test the temperature by
ironing the hem of the garment or
similar area first. If you turn the
control dial down from a hot setting
to a cooler setting, wait until the iron
temperature has stablilised before
you continue ironing.
5 Important note: If the product is
accidentally switched off while
ironing the boiler controls require
approximately 2
1/2
minutes to re-set
before steam ironing can be
resumed.
Steam ironing
1 Ensure that you have filled the boiler
correctly. Allow the boiler to heat up.
2 Consult the heat settings chart page
3, and select the position on the
temperature control dial that
corresponds to the fabric to be
ironed. The iron ready light
›
illuminates and the soleplate heats
up. Wait until the light goes out and
the boiler ready indicator on the
base unit
„
illuminates before
ironing.
3 To obtain steam, press the steam
control button
⁄
and release. Press
the button down again and release
to stop the steam.
5
www.morphyrichards.com
g
⁄
¤
›
‹
fi
fi
·
‚
„
‰
fl
‡
Â
C
42370MCZ-Rev1-SteamGenerator 25/9/06 4:39 pm Page 5