Morphy Richards JET STREAM, Инструкция по эксплуатации

Страница: 6 / 20

6
www.morphyrichards.com
• It is recommended that everytime
the iron is used, the steam control
button be depressed away from the
ironing board. This enables the iron
to discharge cold water. This
process should also be applied
when you have not used steam for
several minutes.
• Alternatively you should first iron on
a towel to absorb any excess water
droplets.
• Perfect ironing can be obtained with
short bursts of steam.
• Note: Water droplets will be
discharged through the soleplate if
you have overfilled the boiler.
• The amount of steam can be varied
by adjusting the steam knob
‰
.
If there is no steam
• In order to fill the boiler whilst in
use, follow the instructions detailed
page 6.
• The boiler has been accidentally
switched off and takes 2
1/2
minutes
to re-set.
Dry ironing
1 Make sure the boiler is full of water.
2 Press the power switch
·
on the
boiler to the ON position
3 Set the temperature control dial on
the iron
¤
to the desired setting.
4 Wait until the iron ready light
›
goes out.
5 The iron is ready for dry ironing.
Note: Pressing the steam button ⁄
delivers steam to the iron, make
sure the temperature dial on the iron
is set to the steam band.
Re-filling the boiler
• The red refill water indicator light
‚
will glow when the boiler requires
filling.
WARNING: Never unscrew the
boiler filler cap as long as the
boiler is under pressure.
Carry out the following procedure to
release the pressure.
1 Press the steam button ⁄ until the
steam stops coming out from the
soleplate. This may take several
minutes, then release the steam
button.
2 Wait until the red refill water
indicator light comes on, then press
the steam button again to release
any residual steam.
3 Switch off and unplug and wait 5
minutes.
4 Very slowly unscrew the boiler filler
cap. If steam is heard escaping or
the cap whistles, stop unscrewing
the cap and wait until all the steam
has gone, then continue to slowly
unscrew the cap.
5 Use the funnel provided and slowly
refill the boiler with water but take
care not to overfill.
6 Screw the boiler filler cap back on
until it is completely tight.
7 Plug in the appliance. Wait for the
boiler ready light to glow, this
indicates that the steam is ready for
use.
WARNING: Never unscrew the
boiler filler cap when the
appliance is connected to the
power supply and whilst there is
pressure inside the boiler. Never
unscrew the filler cap during
ironing.
8 After ironing is completed,
always switch off the steam
control
⁄
.
Vertical steam ironing
D
Hold the iron in a vertical position
between 1cm and 2cm away from
the item. Press the steam button,
this will create vertical steam. This
feature is especially useful for
getting creases out of hanging
clothes, curtains, wall hangings, etc.
Do not keep the steam control
button pressed down continuously,
short bursts of steam are sufficient.
D
42370MCZ-Rev1-SteamGenerator 25/9/06 4:39 pm Page 6