If you wait a few minutes, the steam
station will stabilise at the required setting.
Your Morphy Richards iron is fitted with an
indicator light
·
which will go on and off
while you are ironing.
This is perfectly normal as it shows that
the iron is maintaining the heat setting you
have chosen.
It is always a good idea to begin with
cool fabrics and work up to higher settings.
An iron heats up quicker than it cools
down so you’ll save time and electricity.
Features of your iron
Temperature indicator light
The indicator light shows that the iron is
warming up. When the required temperature
is reached the light will go out and will cycle
on-off during operation.
Dry ironing
You can use your steam station as a dry
iron only.
Any temperature setting may be used
depending on the garment. You do not
need to put any water in the tank when dry
ironing only.
'Click' on - 'click' off steam button
To activate the steam press the steam
button
⁄
once and release. The indicator
light
„
will illuminate, indicating the iron is
in steam mode. The first time you use the
steam station, it will take approximately 30
seconds for the steam to start. Any noise
will be due to the pump removing air from
the system.
To stop the steam, press and release the
steam button
⁄
again.
Note: When the tank needs re-filling with
water the pump will become noisy.
This is quite normal but the tank should
be immediately filled with water. Failure to
do so could damage the steam system.
Anti-scale system
The anti-scale cartridge is designed to
reduce build-up of limescale which occurs
during steam ironing, this will prolong the
working life of your steam station. However
please note that the anti-scale cartridge will
not completely stop the natural process of
limescale build-up.
Anti-scale cartridge replacement
1
Press the release button to the side of
the cartridge.
C
2
Lift out the old unit and replace with a
new one.
3
Press to lock in position.
How often you need to replace your
anti-scale cartridge depends on how often
you use your iron with its steam functions
and how ‘hard’ your water supply is. Water
hardness varies greatly from one area to
another. For advice on the relative hardness
of your water, contact your local water
supplier.
However, please note that the anti-scale
cartridge will not completely stop the
natural process of limescale build-up. If in
average you spend 2 hours per week
ironing, then we suggest you replace your
anti-scale cartridge as shown in the table
below. If you iron more or less frequently
then you should alter the interval between
re-fills accordingly.
5
C
Water hardness
Soft
Medium
Hard
Refill interval
6
3
1
1/
2
(months)
42345 Rev 2 31/5/05 9:39 AM Page 5
