1.0
ProStar MPPT Operator’s Manual
3
• External solaire et la batterie se déconnecte sont néces-
saires.
• Déconnectez toutes les sources d’alimentation du con-
trôleur avant d’installer ou de régler le ProStar MPPT.
• Le TriStar MPPT ne contient aucun fusible ou interrupteur.
Ne tentez pas de réparer.
• Installez des fusibles/coupe-circuits externes selon le
besoin.
Installation Safety Precautions
WARNING:
This unit is not provided with a GFDI device.
This charge controller must be used with an external
GFDI device as required by the Article 690 of the
National Electrical Code for the installation location.
• Mount the ProStar MPPT indoors. Prevent exposure to the
elements and do not allow water to enter the controller.
• Install the ProStar MPPT in a location that prevents casual
contact. The ProStar MPPT heatsink can become very hot
during operation.
• Use insulated tools when working with batteries.
• Avoid wearing jewelry during installation.
• The battery bank must be comprised of batteries of same
type, make, and age.
• UL/IEC 62109 certified for use in negative ground or
floating systems only
• Do not smoke near the battery bank.
• Power connections must remain tight to avoid excessive
heating from a loose connection.
• Use properly sized conductors and circuit interrupters.
• The grounding terminal is located in the case, and is
identified by the symbol below: