Morgana KB2000, Руководство оператора

Страница: 20 / 36

6. SET-UP of Functions
1. Important Information
:
Cleaning of Sensors
The sensor for covers in Cover Station and the sensor for paper in Paper Clamp Assy must be
free from dust or other items in order to achieve correct function. Errors might be caused in
case sensors indicate something without cover placed , nor paper loaded: In this case the
machine might start operation without paper upon start by start-button use.
Only “clean” paper must be bound
In case there are affixed staples or clips or any other subjects onto paper to be bound it might
harm the notching/slitting device seriously! Please prevent those items. In case those papers
have to be bound please under all circumstances shut off the notching/slitting device by switch
on right hand side of machine – next to main switch
Steps to adjust amount of glue….
…for thin or thick glue layer on spine of book.
This is a general adjustment in glue–assembly for the
doctor-roller . The doctor-roller is always clean from glue by it`s
scraper and levels the glue layer which had been applied by the
2 glue attachment rollers in the glue-assy.
The height-position of the doctor roller controls the amount of
glue which should remain on the spine of book.
How to adjust:
Step: 1
A 3mm Allan Key (hexagon-screw-driver) (delivered with
accessory-package) is used to loose/fix the fixing screw of doctor
roller.
Step: 2
The hexagon-shaped adjustment-ring on outer side of glue assy
(on shaft of axle of doctor-roller) has a eccentric function by
turning.
4 of the 6 flat sides of the surface of the said adjustment-ring are
equipped with a centre hole.
Use the 3mm-hexagon driver as a pin for turning the ring.
Turn right =
less glue
Turn left = more glue
Standard set: To be seen from top set hole = 1hole more on left
hand side and 2 holes more on right hand side.
2. How to adjust amount of glue on spine
3 mm Allan Key