Page 11
Page 10
Operating the DocuFold Pro
Operating the DocuFold Pro
Roller Tilt
+
-
Lever (R) should always be set in the ‘0’ (square) position.
To adjust folding
out of square you can move the roller assembly in the + or - direction by releasing
knobs (Y) and moving lever (R) - always re-tighten Knobs (Y)
DocuFold Pro
FOLD PLATES
ALWAYS UNPLUG POWER CONNECTIONS BEFORE REMOVING FOLD PLATES.
Fitting
Fit the fold plates into their respective positions (long fold plate upper and short plate lower), by
locating the front pins (J) into the long slots and carefully sliding forwards (without twisting)
until the rear pins can be located into the short slots. When fully in position, pull down the fold
plate to lock into position. Connect the push-in power connectors - short lead to upper plate & long
lead to lower plate.
Settings
The fold plate lengths are set automatically.
Fold plate Tilt
See roller tilt.
IMPORTANT NOTE:-
If any of the fold plates, or the plug in perforator unit are removed from the machine; the
guard circuit is automatically broken, for safety reasons, to prevent the fold rollers from
rotating.
