Setting the temperature
The water temperature is set by turning the thermostat dial. The required symbol is set in relation to the fixed
point on the control panel.
Warning:
setting the thermostat dial as far to the left as possible does not mean that the heating element is
permanently switched off.
On operation of the heater without blocking of the daily rate, we do not recommend the temperature being set
above the level of 65°C.
Select the maximum symbol
“60”
.
Restriction of the regulation range; blocking settings
(only applies to volumes 50 to 160L).
Due to various safety reasons (unwanted scalding, prevention of manipulation by children or an unauthorised
person) the range of regulation can be
restricted
or
blocked
by setting the thermostat.
Restriction of regulation – pull off the thermostat dial (this will be quite difficult the first time),
You will find two
φ
2.15mm cylindrical pegs on the reverse side
- Pull out one peg and insert it into the appropriate hole for the selected
maximum temperature.
- Refit the dial (as far as it will go).
Blocking settings - Set the selected temperature
Pull of the dial without changing the setting, you will find two pegs on the reverse side,
pull both of these out and insert them into the holes corresponding to the selected
temperature in such a way that there is no hole in the space between the pegs and the
position is opposite the set temperature.
6. MOUNTING ON A WALL (only applies for NTR/Z and MORA-TOPV NTR)
Lower border of heat range
(around 5°C)
Fixed point on
control panel
Temperature “anti-freeze”
(around 12°C)
Upper border of heat range
(approx. 76 to 80°C)
“Optimum” temperature
(around 60°C)
Regulation restriction
Blocking settings
