Mopar EVS II, Руководство по установке

Страница: 13 / 16

13
C. Programming Additional Transmitters
Up to four transmitters can be programmed to
the security or keyless entry system.
Security Systems:
1.
Open the driver’s door.
2. Turn the vehicle ignition to the ON position.
3. Press and hold the Emergency Override / Programming button in.
•
After approximately 15 seconds, the siren will chirp 3 times. This indicates that
the system is in the Transmitter Programming Mode.
4. Release the Emergency Override / Programming button. Wait 5 seconds.
5. Press Button 1 on the new transmitter. The siren should chirp once.
6. Repeat step 5 for any additional transmitters.
7. Exit the Transmitter Programming Mode by turning the vehicle ignition off. Test all
remote transmitters to ensure that they work properly.
Keyless Entry Systems:
1. Open the driver’s door.
2. Turn the vehicle ignition to the ON position.
3. Press and hold the Status Indicator / Programming button in.
•
After approximately 15 seconds, the door locks will cycle once. (If the optional
siren is installed, the siren will chirp three times.) This indicates that the system
is in the Transmitter Programming Mode.
4. Release the Status Indicator / Programming button. Wait 5 seconds.
5. Press Button 1 on the new transmitter. The door locks should cycle once.
6. Repeat step 5 for any additional transmitters.
7. Exit the Transmitter Programming Mode by turning the vehicle ignition off. Test all
remote transmitters to ensure that they work properly.
To delete a lost or stolen transmitter:
1.
Follow steps 1-4 as described above.
2. Re-program the remaining transmitters as described in step 5.
• If there is only one remaining transmitter, perform step 5 four times.
• If two remaining transmitters, perform step 5 twice for each transmitter.
D. Programming Selectable Options
1. Enter the Transmitter Programming Mode (steps 1-4 above).
2. Security: Press and release Emergency Override / Programming Button once.
•
The siren will chirp three more times to indicate entry into the Options
Programming Mode.
Keyless: Press and release Status Indicator / Programming Button once.
•
The door locks will cycle once to indicate entry into the Options
Programming Mode. (If equipped with optional siren, siren chirps 3 times.)
3. Press Transmitter Button 1 to select Option 1.
4. Refer to the appropriate chart (next page) to change options.
6. System Power-Up, Test, and Adjustment