1 2
To change the setting of an option: (for EVS II Systems only)
A. Enter Option Learn Mode, Option Bank 1, as shown on page 10.
B. Press both “Arm” & “Disarm” buttons together to advance to the desired
option (refer to the Option Bank Chart).
The parking lights will flash a number of times indicating which option is
selected (i.e. Two flashes indicates that option number two has been
selected).
C. Press the “Arm” button to change the setting of an option..
The status LED indicates the setting of the option; LED ON indicates that
the option is on, LED OFF indicates that the option is off.
D. To advance to Option Bank 2, at any point while in Option Bank 1,
press
and release
the programming/override button to advance to option bank
number two.
The parking lights will flash 5 times indicating the system
has entered Option Bank 2.
To return back to Option Bank 1, press and release the programming/
override button once again (4 flashes).
Shock sensor setting: (EVS II Systems only)
(Ensure module is mounted before adjustment!)
The “Lite-touch” and “Full shock” sensor settings are always the first and
second options, respectively, in Option Bank 1. To change the shock sensor
setting, follow these steps:
A. Make sure the driver’s window is rolled down.
B. Enter Option Learn Mode, Option Bank 1, as shown on page 10.
C. Press “ARM” & “DISARM” buttons together to go to option #1 for Lite-
touch (
parking lights flash 1 time
).
D. Press the “ARM” button to increase sensitivity and press the “DISARM”
button to decrease sensitivity.
E. Test the shock sensor sensitivity (while in option learn mode) by applying
an impact with an open hand to the windshield.
Caution - make sure to
remove articles of jewelry to avoid scratching or breaking glass.
The parking lights will flash each time an impact is detected that is
greater than the current setting.
F. Once the desired Lite-touch sensitivity is achieved, press “ARM” &
“DISARM” buttons together to advance to option #2 for Full shock
(
parking lights flash 2 times
). Repeat steps D through Eto set Full shock
sensitivity.
G. Press “ARM” & “DISARM” buttons together to advance to the next
option (if necessary).
