Service and Maintenance (cont.)
Removal of Burner Injector (Section 3)
1)
Remove burner as described in Section 2.
Manual Part No: 930006-01
MD Gas Grill
- 26 –
Manual Rev No: 1
2)
Remove the three screws (A) and pull spider (B) of the burner.
3)
Unscrew burner injector (C) from spider and clean or renew as necessary.
4)
To clean the injector, brush off with a stiff bristle brush any dirt; blow through to remove any
blockage or restriction.
DO NOT POKE WIRE THROUGH THE INJECTOR ORIFICE.
To Service (re-grease) and Remove a Gas Tap/FFD (Section 4)
The Gas Tap must be removed from the appliance in order to re-grease
1)
Ensure that the gas supply to the appliance has been turned off before removing or dismantling
any gas controls.
2) Remove
the
control/fascia/top
panel as described in Section 1.
3)
Undo the seven screws fixing the RH side panel and remove.
4)
Disconnect the burner feed pipe and the thermocouple from the gas tap.
5)
Finally remove the single screw and clamp bracket from the gas tap and remove from the gas
manifold pipe.
6)
To Re-Grease the Gas Tap - remove the front cover from the gas tap by unscrewing the two pozi
head screws.
7)
Carefully withdraw the cover taking care not to lose the small spring from inside the tap.
8)
Carefully remove the taper plug from the body.
9)
Clean the plug and inside the body using a lint free cloth and a suitable solvent.
10) Wipe both parts clean and dry. Ensure that all holes are clean and free from obstruction.
11) Lightly re-grease the plug using a suitable high temperature grease such as Rocol and replace the
plug in the body.
12) Lightly grease the inside of the gas taps front cover, position the spring and re-assemble the front
cover to the body.
13)
Replace in reverse order.