www.miinet.com
Moore Industries-International, Inc.
- 24 -
User’s Manual
224-790-00K
May 2018
Programmable Limit Alarm Trips
SPA
2
SECTION 4
Figure 4.0.
SPA
2
Internal Jumper for Password Security
Note:
The password security function of the SPA2 is controlled by a single jumper inside the unit
housing. The default (factory) setting is ‘Password required ‘ as shown above. ‘Full Access’ means
that no password is required.
REMOVE PANEL
BY UNSCREWING
TOP FOUR SCREWS
SET PASSWORD SECURITY
PASSWORD SECURITY
IS OFF. NO PASSWORD
REQUIRED.
PASSWORD SECURITY
IS ON. PASSWORD
REQUIRED.
BACK
TX
+I
COM
+V
-lo Source
+lo Sink
+lo Source
+Vo
-Vo
-lo Sink
INPUT
A OUT
2
SPA TOPSIDE
FRONT
MR
Section 4: Configuration Front Panel Pushbuttons
The SPA
2
operating parameters may be set using front panel pushbuttons and/or Moore Industries’
PC Configuration Software. This section describes configuration via the front panel pushbuttons.
There are three pushbuttons on the unit’s front panel;
UP
,
DOWN
and
SELECT
. Together with
the prompting messages displayed on the LCD, these are used to access menus, and to view and
change the settings.
Use
SELECT
as your “Enter” button, to make your selections.
Use the
UP
and
DOWN
buttons to navigate within the menus.
Note:
Refer to the QuickStart Guide to see the default factory settings for your unit. All
parameters, except the Custom Curve Table feature, can be configured using the front panel
pushbuttons. The Custom Curve table can only be configured using the PC Configuration
Software Program.
