Moomba Craz, Руководство пользователя

Страница: 27 / 72

27
© 2016 Skier’s Choice, Inc.
The tachometer registers the operating speed of the motor’s
shaft output and may be used as an alternative to speedometer
if weight and water conditions permit.
DO NOT exceed the recommended RPM during break-in and
normal operation of your motor. Exceeding the manufacturer’s
suggested RPM may cause damage to the engine.
s
PeeDoMeTeR
The speedometer indicates the water speed of the boat in
miles per hour. It is recommended that the speedometer be
checked for accuracy after each 100 engine hours.
Speed may be checked using a stopwatch and a standard
slalom course. Adjust the speedometer needle by turning
the knob at the bottom of the gauge.
NOTE: If the speedometer registers erratically, check
speedometer pickups.
The fuel gauge is located on the speedometer or tachometer.
This gauge indicates the approximate quantity of fuel remaining
in the tank when the ignition switch is in the “ON” position.
NOTE: DO NOT run the tank to empty. To prevent
condensation from forming in the tank, it is recommended
that the tank be filled when the gauge indicates 1/4 tank
of fuel remaining.
f
Uel
g
aUge
s
PeeDoMeTeR
P
ICkUPs
The speedometer pickup is located on the bottom of the hull. The pickup measures the speed of water
passing the paddlewheel. Poor water conditions or foreign material may clog the pickup causing the
speedometer to register incorrectly.
Inspect the paddlewheel and remove any foreign material only when engine is off.
Please see paddlewheel owner manual in the Boat Owner’s Packet
for more information.
Warning Stickers
Always heed the dash mounted warning stickers.
BEFORE STARTING ENGINE:
Check engine compartment for gasoline or vapors.
Operate blower for four minutes before starting engine.
Run blower below cruising speed.
Turn o engine before using ski platform.
GASOLINE VAPORS CAN EXPLODE!
Engine hours should always be noted and documented so
that required maintenance and lubrication changes may be
performed at the proper intervals. The engine hour meter
indicates the number of hours the engine has run.
Engine hours are shown on the Digital Cruise Pro II home screen
in the bottom left corner.
e
ngIne
H
oURs